Feig Electronic OBID i-scan ID ISC PRHD102, Manual

Page: 22 / 125

OBID i-scan
®
Manual ID ISC.PRHD102
FEIG ELECTRONIC GmbH Page 22 of 125 H71101-2e-ID-B.doc
To change the READER-ID you must write to the CFG0 immediately after the Login to the Reader
with the command 6.10. [0xA0] Reader-Login
Notes:
•
A READER-ID = 0x00000000 disables the password function.
•
A read with the command 5.1. [0x80] Read Configuration will always get
‘0x00000000’.
•
A changed password becomes valid after a Reader reset.
•
The command 5.3. [0x83] Set Default Configuration don’t change the CFG0 regis-
ter if all configuration blocks are used.
•
The command 6.10. [0xA0] Reader-Login is used to enable configuration data
access.
Config Protection
By means of Config Protection, the access to the configuration parameters stored within the Read-
er
is protected by a 32-bit password, the "READER-ID". This means that only after a "Login" with a
valid READER-ID with the command 6.10. [0xA0] Reader-Login can configuration parameters in
the EEPROM of the Reader may be read and changed in the EEPROM of the Reader.