5-51
P01
Motor 1 (No. of poles)
P01 specifies the number of poles of the motor. Enter the value given on the nameplate of the
motor. This setting is used to display the motor
on the LED monitor (refer to E43). The
following expression is used for the conversion.
speed
120
Motor
No. of poles
x Frequency (
speed (r/min) =
Hz)
P02
Motor 1 (Rated capacity)
P02 specifies the rated capacity of the motor. Enter the rated value given on the nameplate of
the moto
Dat
r.
a for P02
Unit
Remarks
kW
When P99 = 0, 3 or 4
0.01 to 30.00
HP
When P99 = 1
P03
Motor 1 (Rated current)
the rated current of the motor. Enter the rated value given on the nameplate of
P04
P03 specifies
the motor.
Motor 1 (Auto-tuning)
m
a
.
a
ing since the motor parameters are different
torq
spe
op.
• C
• A
For
a te
P05
The inverter automatically detects the motor parameters and saves them in its internal
emory. Basically, it is not necessary to perform tuning when using a Fuji standard motor with
standard connection with the inverter
In any of the following cases, perform uto-tun
from those of Fuji standard motors so as not to obtain the best performance under each of
these controls--auto torque boost, torque calculation monitoring, auto energy saving operation,
ue limiter, automatic deceleration (anti-regenerative control), auto search for idling motor
ed, slip compensation, torque vector, droop control, or overload st
• The motor to be driven is made by other manufacturer or is a non-standard motor.
abling between the motor and the inverter is long.
reactor is inserted between the motor and the inverter.
details of auto-tuning, refer to Section 4.1.3 "Preparation before running the motor for
st -- Setting function code data."
Motor 1 (Online tuning)
he primary and secondary % resistances (%R1) and (%R2) will change as the motor
u
is in operation
P08
T
temperat
(online)
P06, P07
re rises. P05 allows you to tune this change when the inverter
, P12
Motor 1 (No-load current, %R1, %X and Motor 1, Rated slip frequency)
ppropriate values from the test report of the motor or by calling the
P06 through P08 and P12 specify no-load current, %R1, %X, and rated slip frequency,
respectively. Obtain the a
manufacturer of the motor.
Performing auto-tuning automatically sets these parameters.
No-load current (P06): Enter the value obtained from the motor manufacturer.
%R1 (P07): Enter the value calculated by the following expression.
(%)
=
1
%R
100
×
)
I
×
3
(
/
V
1
R
Cable
+
1
R
Summary of Contents for FRENIC-Multi series
Page 194: ...MEMO MEMO...
