FE FRENIC-Multi series, Instruction Manual

Page: 54 / 196

3-12
Table 3.9 Menus Available in Programming Mode
Menu # Menu
LED
monitor
shows:
Main functions
Refer
to:
0 "Quick Setup"
*fn:
Displays only basic function codes to customize
the inverter operation. Section
3.4.1
!f__
F codes
(Fundamental functions)
!e__
E codes
(Extension terminal functions)
!c__
C codes
(Control functions)
!p__
P codes
(Motor 1 parameters)
!h__
H codes
(High performance functions)
!a__
A codes
(Motor 2 parameters)
!j__
J codes
(Application functions)
!y__
y codes (Link functions)
1 "Data Setting"
!o__
o codes (Optional function)
Selecting each of
these function
codes enables
its data to be
displayed/changed.
Section
3.4.2
2 "Data Checking"
"rep
Displays only function codes that have been
changed from their factory defaults. You can refer
to or change those function code data.
Section
3.4.3
3 "Drive Monitoring"
#ope
Displays the running information required for
maintenance or test running. Section
3.4.4
4 "I/O Checking"
$i_o
Displays external interface information. Section
3.4.5
5
"Maintenance
Information"
%che
Displays maintenance information including
cumulative run time. Section
3.4.6
6 "Alarm Information"
&al
Displays the recent four alarm codes. You can
refer to the running information at the time when
the alarm occurred.
Section
3.4.7
(Note 1) Mounting a multi-function keypad adds the data copying function to the menu, enabling reading,
writing, and verifying of function code data.
(Note 2)
The o codes are displayed only when the corresponding option is mounted. For details, refer to the
Instruction Manual for the corresponding option.
„
Selecting menus to display
The menu-driven system allows you to cycle through menus. To cycle through necessary menus
only for simple operation, use function code E52 that provides a choice of three display modes as
listed below.
The factory default (E52 = 0) is to display only two menus--Menu #0 "Quick Setup" and Menu #1
"Data Setting," allowing no switching to any other menu.
Table 3.10 Keypad Display Mode Selection – Function Code E52
Data for E52 Mode Menus selectable
Menu #0 "Quick Setup"
Menu #1 "Data Setting"
0 Function code data editing mode (factory default)
1 Function code data check mode Menu #2 "Data Checking"
2 Full-menu mode Menus #0 through #6
Pressing the / key will cycle through the menu. With the key, you can select the
desired menu item. Once the entire menu has been cycled through, the display will return
to the first menu item.