FE FRENIC-Multi series, Instruction Manual

Page: 116 / 196

5-41
Motor 2 imposes functional restrictions on the following function codes. Confirm the settings of
those function codes before use.
Functions Restrictions
Related function
codes
Non-linear V/f pattern Disabled. Linear V/f pattern only H50 to H53
Starting frequency Starting frequency holding time not supported. F24
Stop frequency Stop not supporte frequency holding time d. F39
Overload rning Disabled. early wa E34 and E35
Droop con Disabled trol . H28
UP / DOWN ol Disabled. default setting 0. contr Fixed at H61
PID control Disabled. J01
Braking signal Disabled. J68 to J72
Software current limiter Disabled. F43 and F44
Rotation direction limit 8 ation Disabled. H0
Overload stop Disabled. J63 to J67
To run motor 2 with the M2/
the input of the M2/M1 shou
M1 terminal command and a run command (e. D ),
ld not be delayed 10 ms or mo m that o run
delay exceeds 10 ms, motor 1 will be drive efault.
„
data = 13)
This terminal command gives t and through the inverter’s digital
input.
(Refer to the descriptions of F .)
„
ue limiter level -- ta = 14)
T torqu er 2
(
If command is assigned, torque limiter 1 (F40 a 1) takes
d
d TL2 / TL1 Torque limiter
g., FW
f the re fro
command. If the n by d
Enable DC braking -- DCBRK (Function code
he inverter a DC braking comm
20 to F22 for DC braking
Select torq TL2 / TL1 (Function code da
his terminal command switches between torque limiter 1 (F40 and F41) and e limit
E16 and E17) as listed below.
no TL2/TL1 terminal nd F4 effect by
efault.
Input terminal comman level
OFF Torque limiter 1 (F4 F41) 0 and
ON Torque limiter 2 (E16 and E17)
„
ency) commands
•
W a ru mand O ing
t ency ease or ase,
respectively, within the range cy as below.
UP DOWN
UP (Increase output frequency) and DOWN (Decrease output frequ
-- UP and DOWN (Function code data = 17, 18)
Frequency setting
hen the UP / DOWN control is selected for frequency setting with n com N, turn
he UP or DOWN terminal command ON causes the output frequ to incr decre
from 0 Hz to the maximum frequen listed
Data = 17 Data = 18
n Functio
OFF OFF uency. Keep the current output freq
ON OFF
Increase
currently s the output frequency with t eration e
pecified.
he accel tim
OFF ON
Decrease the output frequency with t ecelerati e
currently specified.
he d on tim
ON ON Keep the current output frequency.