FBI XL-1T, Installation And Setup Manual

Page: 55 / 72

8–1
S E C T I O N 8
Data Entry via LED and LCD Keypads
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
This section describes the physical keystrokes necessary to perform keypad programming,
and how to interpret the data displayed on the LED-based keypads (XK-104) and on the LCD
keypads (6805) during programming operations.
Actual keypad programming should be performed after completion of the programming sheet.
Entering Programming Mode via Either LED or LCD Keypads
The system programming mode can be entered while disarmed only as follows:
TO ENTER INSTALLER PROGRAMMING, PRESS [CODE][
✱
][INSTALLER][1]
Where:
[CODE] CODE button
[
✱
] [
✱
] key
[INSTALLER] The 4-digit Installer Code (default = 2468)
[1]
The 1 key. This indicates Installer Mode 1.
What You See on the LED Keypad
Program Mode = READY LED:
Upon entering the installer Keypad Programming mode, the READY LED will slowly pulse,
and will continue to pulse until leaving this mode. The remaining LEDs display the question
number and location contents as indicated below:
ARM
INSTANT
STAY
XK-104
AC/LB
READY
1
2
3
4
+ 1
+ 2
+ 4
+ 8
SLOWLY PULSING
+ 1
+ 2
+ 4
+ 8
+ 16
QUESTION
NUMBER
LOCATIONS
CONTENTS
(DATA)
Figure 8-1: XK-104 Keypad
Question Numbers = Zone LEDs
There is a total of 22 questions with multiple data entry locations.
Zone LEDs 1 through 5 display the current question number, not the specific location within
each question. In the diagram on the following page, the question number is the sum total
value of all LEDs that are ON.