FBI XL-1T, Installation And Setup Manual

Page: 27 / 72

5–1
S E C T I O N 5
System Operation
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Power-Up/System Reset
SYSTEM STABILIZATION MODE: Upon initial power-up of the system, all of the
lights on the LED keypad(s) will blink ON and go OFF for approximately 2 min. 10
sec. and/or the LCD keypad(s) will display STAND BY! for approximately 2 min. 10
sec. This occurs on a total power-up (if armed or disarmed in its prior state) or
after a system reset. If the total system power is lost, the system will return to the
previous arming state upon restoration of power. The 2 min. 10 sec. interval is
used to allow motion detectors (interior zones) to stabilize on power-up in order to
prevent false alarms.
Please note, this option can be disabled by momentarily, for a minimum of five
seconds, by putting a jumper between terminals 13 and 12.
Arming the System
The system can be armed only if all burglary zones are not faulted. On LED-based keypads,
this requires that the READY LED be ON.
On LCD keypads, the following message will appear:
SYSTEM: READY
TO ARM: Enter any programmed four-digit user cODE.
The factory default for user 1 is 1234.
The ARMED LED will light, and the user may exit through an exit/entry zone for the time
period programmed as the exit delay. The system can be armed without the backup battery
being connected; however; the AC/LB light will flash.
LCD-based keypads will display:
ON: AWAY
Stay Arming
TO ARM: Press the STAY button followed by a four-digit User Code.
The ARMED and STAY LEDs will light on LED-based keypads.
LCD-based keypads will display:
ON: STAY
The system is now armed with all programmed interior zones excluded.