FBI XL-1T, Installation And Setup Manual

Page: 35 / 72

Section 6 – Installer Modes
6–3
The CS downloading computer must be waiting in the Unattended Communications mode and be
preprogrammed with the account information in order for the Unattended Download to be
functional.
Installer Mode 4 (Online Download)
In this mode, the installer can initiate a remote communications session with the CS
downloading computer at the control panel location. Typically, a remote communications
session is initiated by the CS. On-line downloading allows the installer to call the office (from
the same telephone line as the panel), discuss the action required, and complete the request
while on-line. No additional telephone call is needed. On-line connection can be made as
follows:
1. After completing the installation, attach a handset to the Telco terminals (tip and ring) or
uses the standard home telephone to dial the CS downloading modem telephone line.
Connection is made with a person at the CS downloading computer, and the account to be
downloaded is verbally identified. The downloading computer operator selects On-line
Remote Operations from the Device menu.
2. Enter the on-line download sequence: [CODE] [
✱
] [INSTALLER] [4], or use the end-
user command of [#] [9], if enabled. This will cause the control panel to act as if it
received a request for a remote communications session and to look for the standard panel
to CS protocol.
3. Once the standard connection is made, the necessary remote communications sessions can
take place (upload, download, and remote commands).
4. Hang up the telephone or remove the headset from the line to prevent interference that
may affect upload/download data. The downloader software will automatically terminate
the connection after remote communications end.
On-Line Download (#9)
If On-Line Download is programmed (see programming question 05, location 4), the user can
initiate a remote communications session with the CS downloading computer at the control
panel. Typically, a remote communications session is initiated by the CS. On-line
downloading allows the user to call the office and discuss the action required, and allows the
CS operator to complete the request while on-line. No additional telephone call is needed.
The on-line connection can be made as follows:
1. The user dials the CS downloading modem telephone line from the premises’ telephone
line that the alarm system uses. Connection is made with a person at the CS downloading
computer, and the account to be downloaded is verbally identified. The CS computer
attempts to establish a connection with the site.
2. The user is instructed to enter #9 on the keypad, causing the control panel to act as if it
received a request for a remote communications session and to look for the standard panel
to CS protocol.
3. Once the standard connection is made, the remote communications session can take place
(upload, download, and remote commands).
4. The user hangs up the telephone to prevent interference that may affect upload/download
data. The downloader software automatically terminates the connection after remote
communications end.