FBI XL-1T, Installation And Setup Manual

Page: 38 / 72

XL-1T Installation and Setup Guide
7–2
QUESTION 02
SECONDARY TELEPHONE NUMBER
DEFAULT = AAAAAAAAAAAA
Enter the telephone number, including area code and/or dialing prefix, of the secondary
central station receiver in L1 - L12.
Enter the valid digits from the table in question 01. The secondary telephone number will be
used if the panel is unable to reach the central station via the primary number. This is
known as backup reporting. If the Split Reporting feature is programmed, opening and
closing signals will be directed to the secondary CS number only, while all other conditions
will be reported to the primary number.
If neither split nor backup reporting is necessary, this question may be left as factory-
defaulted, and all conditions will be routed to the primary telephone number only.
QUESTION 03
CALLBACK TELEPHONE NUMBER
DEFAULT = AAAAAAAAAAAA
Enter the telephone number, including area code and/or dialing prefix, needed for this
control panel to reach the callback location. The callback number is the optional location of
the EZ-Mate downloader where the control panel will call during a remote communications
(upload/download, etc.) session. During remote communications, the programming device
and the control panel will first confirm the CS Security Code. If valid, communications can
begin. If a callback number is defined, the control panel will the hang up and dial the
callback number. Enter the valid digits from the table in question 01.
For no callback capability, enter AAAAAAAAAAAA.
QUESTION 04
CS DIALER OPTIONS
DEFAULT = 0511
There are 4 locations (L1-L4) within this question defining various dialer and system
options:
Question 04, L1
CS Dialer Formats
DEFAULT = 0
Enter the digit for the desired dialer format from the table below.
Digit CS REPORTING FORMAT FORMAT TRANSMISSION TYPE
0 3x1 Standard PULSE
1 4x1 Standard PULSE
2 3x1 Extended PULSE
3 4x1 Extended PULSE
4 3x1 Partial Extended PULSE
5 4x1 Partial Extended PULSE
6 3x2 PULSE
7 4x2 PULSE
E ADEMCO Point ID * DTMF
* These formats require a high/low handshake frequency from
the CS receiver.
For more information on CS Reporting Formats, refer to Appendix A at the back of this manual.