FBI XL-1T, Installation And Setup Manual

Page: 53 / 72

Section 7 - System Programming
7–17
four minutes after detection. Low Battery Restore Code will be reported within four minutes
after detection of Good Battery condition.
QUESTION 19
CS CODES for OPEN/CLOSE and CS TEST
DEFAULT = AAAA
There are four locations, L1-L4, in this question.
Question 19, L1 - Opening Code Default = A
Question 19, L2 - Closing Code Default = A
L1 is the single-digit Opening Code. L2 is the single-digit Closing Code. Entry of AA into
these two locations means that openings and closings are not desired. If a dialer format other
than the standard is programmed, the second digit transmitted will be the user number.
Question 19, L3 and L4 - CS Test Code Default = AA
L3 - L4 is the CS Test Code. Entry of AA means that CS Test is not enabled. If CS Test Code
is selected, any valid transmission will reset the CS Test timer.
QUESTION 20
CS CODES for BYPASS, RESTORE, TROUBLE and CANCEL
DEFAULT = AAF8
There are four locations, L1 - L4, in this question.
Question 20, L1 - Bypass Code Default = A
L1 is the single-digit system Bypass Code that will be reported to the central station if a zone
is bypassed, upon arming. Entry of an “A” means that bypasses are not transmitted. If a two-
digit dialing format has been selected, the Bypass Code will be followed by the programmed
second digit of the Zones Code.
Question 20, L2 - Restore Code Default = A
L2 is the single-digit system Restore Code reported to the central station. This is the system
Restore Code for AC loss, low battery, etc. Restores will be reported for all burglary or 24-
hour zones by entry of any code except “A”, and enabling transmit zone restores in question
#07, location 2. Entry of an “A” means any type of restore is not transmitted. If a two-digit
dialer format has been programmed, the Restore Code will be followed by the programmed
second digit of the Zone Code.
Restore is not selectable by zone.
Question 20, L3 - Trouble Code Default = F
L3 is the single-digit system Trouble Code reported to the central station. This code will be
reported on day trouble and any fire trouble. If a two-digit format has been programmed, this
code will be followed by the second digit of the respective Zone Code.
Question 20, L4 - Cancel Code Default = 8
L4 is the single-digit system Cancel Code reported to the central station. This code will be
sent if, after a violation of a controlled zone, a User Code is entered. If the zone is still
violated, entry of a User Code will transmit the Cancel Code. If the zone is programmed for
restoration, the Restore Code will be transmitted when the loop status has returned to
normal. An entry of “A” in this field indicates that Cancel Codes are not transmitted. In
formats requiring two digits, the user number functions as the second digit.