FRONT SUSPENSION AND STEERING
Read section A and B completely prior to operation or repair of golf car
C-10
Socket 13# ........................................................... 1
Inner snap ring pliers ............................................ 1
Outer snap ring pliers ........................................... 1
Bearing separator ................................................. 1
Remove the steering wheel and universal joint (as stated before). Remove the combination switch (8)
and ornament strip (25), and remove the four connecting bolts (19) that secure the steering column (9)
(Ref Fig. C8). Remove the steering column from vehicle body. Use inner snap ring pliers to remove the
inner snap ring (18), use outer snap ring pliers to remove the outer snap ring (24), press down the
bearing from steering shaft (12), and remove the steering shaft from the steering assembly.
Reinstall the steering shaft in reverse sequence. Tighten the bolt (19) to 18-22ft lb (24-30 N.m).
Fig. C8: Steering Components
Steering Gear Case Assembly Replacement
Tool List
Qty. Required
Sharp nose pliers ................................................. 1
Ball joint separator................................................ 1
Plastic faced hammer ........................................... 1
Air impact wrench ................................................. 1
Socket 16# ........................................................... 1
