Extreme Networks Summit WM3000 Series, Reference Manual

Page: 308 / 513

Controller Services
Summit WM3000 Series Controller System Reference Guide
308
10 To use the onboard SOLE engine to locate Ekahau tags check the Enable checkbox. This is enabled
immediately after checking the box.
11 If the onboard SOLE engine is enabled to locate Ekahau tags, enter a Locate Interval in seconds to
specify how often the known tags are located by the SOLE engine.
12 Click the Apply button to save the Locate Interval value.
13 Click the Revert button to cancel any changes made within Locate Interval value and revert back to
the last saved configuration.
If the onboard SOLE engine is enabled to locate Ekahau tags the following information will be
displayed for each located MU:
NOTE
Zone configuration can be defined using the CLI interface only. For information on Zone Configuration please see the
Summit WM3000 Series Controller CLI Reference Guide.
MAC
Lists the MAC Addresses of all MUs which have been located by the
controller.
Location:
X Coordinate
Displays the value of the X Coordinate for each located MU. The X
coordinate is relative to the origin point of 0,0 in the upper left corner of
the site map.
Location:
Y Coordinate
Displays the value of the Y Coordinate for each located MU. The X
coordinate is relative to the origin point of 0,0 in the upper left corner of
the site map.
Timestamp
Displays the last time for each MU that its location was computed by the
controller.
Zone
Lists the last known zone for each located MU. Zone configuration can be
defined using the CLI interface only. When no zones are configured, the
controller defaults the entire site to Zone 0.