Basic Operations
81
*2
When media holding plates are attached, within 5 mm (0.2 inch) of the left and right edges of the media is recognized
as the media edge.
For example, if the Side Margin is set to 5 mm (0.2 inch), the actual margin is 10 mm (0.4 inch). Note that if the media
holding plates are attached incorrectly, this value fluctuates. See “Loading Media” on page 31.
*3
The value when jobs are printed continuously. Differs by the length the media was pulled when the media is loaded.
*4
The value selected for
Side Margin(Left)
in the setup menu. The default value is 5 mm (0.2 inch).
*5
The total of the values selected for
Print Start Position
and
Side Margin(Right)
in the setup menu. The default
settings for
Print Start Position
and
Side Margin(Right)
are 0 mm and 5 mm (0.2 inch).
*6
Leave left and right margins of 10 mm (0.4 inch) or more when using media holding plates. Narrower margins could
result in printing over the plates.
Note:
❏
When side margins are configured on both the printer and RIP, this becomes the combined
value.
❏
If the total of the print data width and side margin exceeds the printable area, a portion of the
data will not be printed.
❏
If the following points are not observed when
Media Size Check
is
Off
, printing may occur
outside the left and right edges of the media. Ink used outside the edges of the media will
stain the inside of the printer.
❏
Ensure that the print data width does not exceed the loaded media width.
❏
When media is loaded to the left of the right side reference position, align the
Print Start
Position
setting with the position where the media set. See “The Printer Setup Menu” on
page 124.
