Epson 6110i - PowerLite XGA LCD Projector, User Manual

Page: 80 / 130

80
Monitoring the Projector Over a Network
Monitoring Your Projectors
The EMP Monitor screen lets you monitor your projector(s) status
and check if a problem has occurred.
For the most current status, click the
Refresh
button.
The following table describes the EMP Monitor status icons:
Group status icons
No warnings or problems. All projectors in the group
are operating normally.
Warning or problem. A projector in the group has a
warning or problem.
Notification. A projector in the group requires
immediate attention.
Monitoring disabled. Right click the icon and select
Monitoring Enabled to begin monitoring the group.
Data is currently being updated.
Type status icons
No warnings or problems.
Warning or problem.
Notification.
Monitor Password error. No monitor password was
entered when the projector was registered, or an
incorrect password was entered.
Monitoring disabled. Right-click the icon and select
Monitoring Enabled to begin monitoring the
projector.
Data is currently being updated.
Network error (for example, the projector is not
connected to the network, or power cable is
disconnected).
You may also see this error if
Network Off is
selected in Standby Mode (see page 61).
Network error (Esc/VP.net communication error).
note
To monitor a projector
when it’s in standby mode
(plugged in but not turned
on), you must select
Network On
as the
Standby Mode
setting in
the projector’s menu system
(see page 61).
For detailed status
information, right-click the
projector and click
Property
.
note
To create projector groups in
EMP Monitor, refer to the
on-screen
Operation
Guide .