Aurorean Installation & Service Guide
17
Chapter 2
Mounting the ANG/APS-3000/7000
Mounting & Connecting Systems
Attach the Chassis Sections to the System
To attach the system to the rail chassis sections, perform the following steps:
1
Align the holes in the chassis section with the holes in the system as
shown in Figure 10. Do not use the front hole on the system.
2
Fasten the chassis section to the side of the system with four 10/24 x
0.25” panhead Phillips screws.
Figure 10
Attaching Chassis Sections to the System
Attach Front Brackets to the Rail Assemblies
To connect the front brackets to the rail assemblies, perform the following
steps:
1
Slide the rack section so the screw holes show through the
rectangular opening in the slider section, as shown in Figure 11.
2
Place the front bracket against the rack section.
3
Line up the slot in the bracket with the holes in the rack section.
Chassis section
Panhead screw
