66
Aurorean Installation & Service Guide
Configuring the Remote ANG-3000/7000
Chapter 3
Installing Software & Setting Networking Configurables
properties. The values displayed are default parameters.
–
Status: the RIP state after changes are applied
–
Version: RIP v1 or v2
–
Route Import: learn or not learn routes
–
Route Export: broadcast or not broadcast routes
–
Authentication: simple
algorithm or none
2
If used, type the RIP Password and then confirm the entry in the fields
provided.
3
Click Apply Changes.
Setting OSPF Properties
If your trusted network uses OSPF and you want the ANG to learn and
broadcast OSPF routes, perform the following steps:
1
Click the OSPF tab in the Routing Configuration Window.
The OSPF Configuration window appears as shown in Figure 45.
Figure 45
ANG OSPF Routing Configuration Window
2
Set the OSPF configuration state to Enabled or Disabled after
changes are applied.
