Aurorean Installation & Service Guide
41
Chapter 3
Installing New System Software on the ANG-3000/7000
Installing Software & Setting Networking Configurables
using the following arguments:
–
MM
- the current month (01 - 12).
–
DD
- the current day (01 - 31).
–
hh
- the current hour in 24-hour style (01 for 1 AM, 13 for 1PM).
–
mm
- the current minute (00 - 60).
–
YY
- the current year. Use the last two digits (01 for 2001).
2
After entering the date and time, press
ENTER
.
The new date and time will be displayed. For example, entering
123014150001
will display:
Sat Dec 30 14:15 EST 2001
NOTE
To synchronize the hardware clock “BIOS” to the system clock, at the
command line type setclock then press
ENTER
.
Reboot the ANG
1
On the ANG command line, type:
reboot
and press
ENTER
.
This action will disconnect your Telnet session. You must wait a few
minutes before the ANG reboots. You can test when the reboot is
complete by performing the following steps.
2
Open another DOS window.
3
At the command prompt, type:
ping -t 192.168.1.2
.
Wait for the
“Reply from 192.168.1.2” message to display.
Once you see the above message display, continue with
ANG-3000/7000 general configuration on the next page.
CAUTION
If you migrate the
Management.db
from one APS to another, or revise
tunnel information stored in the
Management.db
, you must reboot the
ANG following the change because the ANG now transmits information
to the APS. Failure to reboot the ANG will cause a client kit build to fail.
