Aurorean Installation & Service Guide
121
Appendix D
Upgrading from Release 2.x to 3.5
Aurorean System Upgrades
Install the ANG Software
1
Telnet to the trusted IP address of the ANG and log in (the default
username and password are
netadmin
and
netadmin
).
2
Type
su - root
and press
ENTER
.
The default password is
welcome
.
3
Type
cd /home/ftp/pub
and press
ENTER
.
4
Remove the pre-installed ANG software before installing version
3.1.
x. T
ype
rpm -e - -allmatches rts
and press
ENTER
.
5
Type
rpm -i --force rts-3.5.xx-xxx.i386.rpm
and press
ENTER
.
Ignore several warning messages which appear during installation.
6
At the end of installation, the following message appears:
'Building devices for the River. This can take several minutes'
7
When the Linux prompt (#) returns, type:
reboot
Verify the VPN is Up and Running
Perform the following steps to use Admintool, a script to verify the ANG
configuration is correct:
1
When the ANG has rebooted and is available on the network, open a
Telnet window on the APS or your laptop and Telnet to the trusted
interface of the ANG.
2
Log in as
netadmin
, with the password
netadmin
.
3
Type
su -
and press
ENTER
.
Type the root password
welcome
and
press
ENTER
.
4
Run the Admintool script by typing
./admintool
to verify proper
configuration.
The following information will display:
Aurorean Network Gateway Administration Utility
1) Configuration and Administration
2) VPN Configuration and Installation Check
