Aurorean Installation & Service Guide
81
Chapter 3
Configuring the Remote ANG-3000/7000
Installing Software & Setting Networking Configurables
Setting PPTP Parameters
To set the PPTP parameters of the ANG, perform the following steps:
1
Click on the Protocols option.
The IPsec Configuration window appears as shown in Figure 57.
2
Click on the PPTP tab.
The PPTP configuration window appears as shown in Figure 58.
Figure 58
ANG PPTP Configuration Window
3
Choose to Enable or Disable 128-bit Encryption.
This option can enable 128-bit key Microsoft Point-to-Point
Encryption (MPPE) on the tunnel. To support 128-bit keys, the ANG
may require a 128-bit encryption upgrade available from Microsoft.
NOTE
If 128-bit encryption is chosen, ANGs with 40-bit encryption will not be
able to connect over PPTP with Aurorean Virtual Network.