74
Aurorean Installation & Service Guide
Configuring the Remote ANG-3000/7000
Chapter 3
Installing Software & Setting Networking Configurables
Configuring Authentication Parameters
Authentication for ANGs in a site-to-site configuration is employed for
terminating tunnel servers only and for administrator access to the Aurorean
Web Config tool. If you are configuring an initiating Network Gateway, skip
to “Configuring Protocols Parameters” on page 78.
To set the Authentication parameters of the ANG, perform the following
steps. We recommend configuring Group values before User values.
Setting Group Parameters
To set the Group parameters on the ANG, perform the following steps:
1
Click on the Authentication option.
2
Click on the Group tab of the Authentication configuration window.
The Group configuration window appears as shown in Figure 53.
Figure 53
ANG Groups WIndow
3
Click Add Group.
The Add Group configuration window appears as shown in
Figure 54.
