Connected Products
Gateway Installation Guide
ZGW-LORA-W1
Zurn Gateway
Page 1: ...Connected Products Gateway Installation Guide ZGW LORA W1 Zurn Gateway ...
Page 2: ... needed Using a different power supply may damage the device and voids the warranty Connectors and LEDs Note Some features are available only on select models The above image shows the model with all features ITEM DESCRIPTION CONNECTORS Power 5 volt power jack Ethernet RJ45 Ethernet jack WPS Reserved for future use SIM Cellular models only SIM slot RECESSED BUTTON Reset Reset button reboots device...
Page 3: ... the LoRa LED to turn ON solid and the cell LED if LTE enabled to flash once every 3 seconds Should take around 1 2 minutes depending on location Your gateway is now ready to transmit data from your Zurn connected product ITEM DESCRIPTION LEDS Status Blinks when operating system is fully loaded LoRa LoRa service active LED displays ON when actively connected and OFF when not connected Cell Cellula...
Page 4: ...the gateway and other devices Note the LoRa antenna location The signal will be strongest radiating from that side of the device The LoRa antenna is 31 2 mm long The LoRa antenna is an omni directional antenna but for best results mount the device so the LoRa antenna is in a vertical position near the top of a wall We recommend conducting a site survey to test the signal strength in different loca...
