Emerson Rosemount 1056, Instruction Manual

Page: 75 / 126

67
6.11.4 Units
The display screen for selecting measurement units is
shown. The default value for temperature is displayed in
bold type. Refer to the current input Programming flow
diagram to complete this function.
If Pressure is selected as the measurement type for
mA Input, the following display screen is shown:
Current input can serve as a universal measurement
board. 4-20mA current input can be accepted from any
device and assigned to represent a wide range of
measurements. If Other is selected as the measure-
ment type for the 4-20mA current input board, the fol-
lowing display screen is shown:
6.11.5 Input Range
The display screen for selecting the Input Range is
shown. The default value for mA Input is displayed in
bold type . Refer to the current input Programming
flow diagram to complete this function.
The current input board can also be used to accept a
4-20mA current input from a pulse flow sensor. If
Flow is selected as the measurement type for the
4-20mA current input board, the following display
screen is shown:
Any of the following units can also be selected to represent the 4-20mA current input. Simply scroll down to
identify and select the desired measurement units as listed in the table below.
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
S N Units
°C
ºF
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
S N Units
%
% Saturation
pH
mV
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
S N Input Range
4-20mA
0-20mA
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
S N Units
mm Hg
in Hg
atm
kPa
mbar
bar
S1: 1.234µS/cm 25.0ºC
S2: 12.34pH 25.0ºC
S N Units
GPM
GPH
cu ft/min
cu ft/hour
L/min
L/hour
m3/hour
µS/cm ppm µg/L NTU ft/sec
mS/cm ppb
mg/L FTU m/sec
MΩ-cm g/L FNU
kΩ-cm ‰ none
Instruction Manual
LIQ-MAN-1056
Section 6.0: Programming the Measurements
April 2017