EMBRON Hatteland X Series, User Manual

Page: 90 / 134

90
IND100129-192
All specifications are subject to change without prior notice!
Specifications - HD 55T22 MVD-AAx-LOGx
SPECIFICATIONS
Note: All specifi cations are subject to change without prior notice!
Please visit www.hattelandtechnology.com for the latest electronic version.
2/2
• W:1360.68 [53.57''] x H:See below x D:See below mm [inch]
• Height from Max: 992.00 [39.05"] to Min: 907.78 [35.74"] mm [inch]
• Depth from Max: 589.27 [23.20"] to Min: 354.96 [13.97"] mm [inch]
• Approx. 115.5kg / 254.1lbs (including optional HT C02 computer)
• Approx. 102.5kg / 225.5lbs (without optional HT C02 computer)
• High Quality TFT with LED Backlight Technology
• 55.0 inch viewable image size, Widescreen, Aspect Ratio 16:9
• TFT active-matrix liquid crystal panel, RGB vertical stripe
• MVA (Multi-domain Vertical Alignment) LCD Technology
• Native Resolution : 3840 x 2160 (UHD, 4K)
• Pixel Pitch (RGB) : 0.315 (H) x 0.315 (V) mm
• Response Time : 6.5 ms (typical) (G to G)
• Contrast Ratio : 4000:1 (typical)
• Light Intensity : 450 cd/m ² (typical)
• Viewable Angle : +/- 89 deg. (typical) (Up/Down/Left/Right)
• Active Display Area : 1209.6 (H) x 680.4 (V) mm
• Max Colors : 16.7 million
A P P R O V A L S & C E R T I F I C A T E S
Physical Considerations:
TFT Technology:
TFT Characteristics:
These products have been tested / type approved by the following classification societies:
IEC 60945 4th (EN 60945:2002) IACS E10 EU RO MR - Mutual Recognition ClassNK - Nippon Kaiji Kyokai
CCS - China Classification Society
• 115&230VAC - 50/60Hz
Power Consumption:
Operating with HT C02 computer : 300W (typ) - 430W (max)
Operating without HT C02 computer : 250W (typ) - 380W (max)
Power Specifications:
Resolutions:
VGA (640 x 350) to UHD (3840 x 2160*)
- Review Timing Table in User Manual
*
Recommended for optimal picture quality
Supported Signals:
• Operating : Temperature -15 deg. C to +55 deg. C
• Storage : Temperature -20 deg. C to +60 deg. C
• Humidity : Up to 95% (Operating / Storage)
• IP Rating : Protection: IP66 front - IP22 rear (EN60529)
• Compass Safe Distance : Standard: 410cm - Steering: 240cm
Lifetime Considerations:
Even though the test conditions for bridge units provide for a maximum
operating temperature of 55°C, continuous operation of all electronic
components should, if possible, take place at ambient temperatures of only
25°C. This is a necessary prerequisite for long life and low service costs.
• Projected Capacitive Touch Screen (Multitouch, USB, Pen/Glove support)
• Color Calibrated models (ECDIS)
Environmental Considerations:
Factory Options:
• Digital separate synchronization
• Composite synchronization
• Synchronization on green
• Auto detects VGA -> UHD (Supports VESA Standards)
Synchronization Range:
• Horizontal : 31.44 kHz to 133.31 kHz
• Vertical : 30 Hz to 70 Hz
Synchronization:
• Optical Bonding Technology
• 1 x 5240-15: Fabric Protection Top Cover, Stretch/Washable, Cotton
Factory Default:
On right side - Glass Display Control™ (GDC) IP66:
• Power On/Off (display), On Screen Display Menu, Brightness Control (-/+)
• Hotkeys (left/right), Mode Status Indicators (ECDIS, Service)
• Buzzer (not visible), Light Sensor (not visible)
• Main Power ON/OFF switch (switch for internal Computer and Display)
Under Right Side:
• Tilt Button Controls
User Controls:
• USB2.0 (<5m) : 2 x USB Type A (4-pin) - Right side of Floor Base
Floor Base Signal Terminals:
• HDMI 1.4 Input : 2 x 19p HDMI (female) - Max 3840x2160@30Hz
• HDMI 2.0 Input : 1 x 19p HDMI (female) - Max 3840x2160@60Hz
• DP 1.2 Input* : 1 x 20p DisplayPort (female) - Max 3840x2160@60Hz
• SCOM+Touch* : 1 x USB TYPE A Connector (female)
• SCOM RS-422/485 : 1 x 5-pin Terminal Block 3.81 non-is Buzzer
• SCOM Ethernet : 1 x RJ45 Connector
• SCOM RS-232 : 1 x 9p D-SUB (female) non-isolated
• User Interface : 1 x 9p D-SUB (male) - Potentiometer Analog Input,
User Brightness (BRT), I2C and +5VDC & 12VDC OUT
• SW Interface : 1 x USB TYPE A (female) for Firmware Update
• GDCx Interface : 1 x 15p D-SUB (male) for GDC Hardware Comm.
• AC Power IN : 1 x Junction Box enclosure w/Terminal Block
Internal Signal Terminals:
* If optional HT C02 computer was delivered with Floor Tilt Model, these are
connected by factory default to the internal Computer.
If no optional HT C02 computer was delivered with Floor Tilt Model, the miniDP, USB
Touch and AC Cables are provided to allow connection to alternative computer.
• HD REM SX1-A1 : 1 x External Remote Control, EN60945 Tested
• 5240-15 : 1 x Fabric Protection Top Cover, Stretch/Washable, Cotton
Please see user manual/datasheet for more information
Available Accessories:
• Tactor (Rotation Angle Value, X/Y Position, 1 x Button) supported Model
• Active Stylus Pen Supported Model
Prepared for:
Floor Tilt Model