EMBRON Hatteland X Series, User Manual

Page: 30 / 134

30
Installation Procedures
Installation
IND100078-38
Access to Display Connectors (Table Model)
The Chart & Planning Table comes preconfigured from factory if a internal Computer was factory mounted. In other cases, review
this section to reveal all the regular Signal Input/Output connectors available on the 55 inch Display. You can find details on all
connectors in the “Physical Connections” chapter later in this manual.
Note: Illustrations below may deviate slightly from written instructions (based on how the unit was delivered/tested prior to actual
installation onboard occurs). All procedures should be performed by a skilled technician that can interpret the physical parts and
correctly identify them on the illustrations below for correct installation).
▼1: Location of the Top Ceiling Panel to remove. Notice
this panel is located just above the front mounted Main
Power Switch and USB connectors.
▼2: Remove 6 screws as indicated to remove the Top Ceiling Panel
▼3: Connectors available on the Display unit is revealed. Connect the cables you need to, and make sure to secure them with
tie-wraps and make sure the cables will not interfere with Tilt/Lift mechanics or get squeezed by movement when using the Tilt/Lift
functions. A good tip is to power on the unit, then try MAX TILT and MAX LIFT together with MINIMUM TILT and MINIMUM LIFT and
observe that the cables are unharmed/long enough and does not interfere in any way. Reverse the procedure to mount the panel back
on.