EMBRON Hatteland X Series, User Manual

Page: 45 / 134

Physical Connections
45
IND100133-58
(USER) POTENTIOMETER I/O:
Allows for controlling Brightness of the displayed image on screen by connecting an external remote control to the
D-SUB 9P connector (male) connector which has Potentiometer Analog Input, User Brightness (BRT), I2C and +5VDC
& 12VDC OUT functionality built in. Review the “Pin Assignments” chapter in this manual for more information on how
to activate this functionality.
RS-232 I/O / SCOM:
This D-SUB 9P connector (female) connector provides additional functionality for the unit. The Serial Remote Control
(SCOM) features a RS-232 (non-isolated) interface for controlling internal parameters like brightness. You can access
most of the parameters available in the OSD menu and with special commands control the unit externally. This COM
can also be used to upgrade the firmware for the graphic controller inside the unit which is available on request and
through service channels (for qualified personnell only). Fasten your external cable to the connector using the
provided screws on the cable housing.
Please review “Management Settings/Communication” in the “OSD Menu Functions” chapter for more information.
Hatteland Technology’s Serial Remote Control Interface (SCOM) protocol document can be downloaded from:
https://www.hattelandtechnology.com/hubfs/pdfget/inb100018-6.htm
Network/LAN I/O / SCOM:
Supports 10/100/1000Mbps Ethernet (LAN). Suitable for twisted pair cables CAT.5E. Make sure the network cable
connector ”clicks” into the RJ-45 connector. This connector will allow remote control of the display unit to control
common functions like brightness, input source and more via the Serial Remote Control (SCOM) as provided by
Hatteland Technology.
Hatteland Technology’s Serial Remote Control Interface (SCOM) protocol document can be downloaded from:
https://www.hattelandtechnology.com/hubfs/pdfget/inb100018-6.htm
USB TOUCH SCREEN / SCOM:
Connect a TYPE A USB Cable between this connector and your PC. Port is USB2.0 (<5m). This connector transmit
touch screen signal from the display unit (if factory mounted) to connected computer. In addition it also simultanously
supports remote control of the display unit to control common functions like brightness, input source and more via the
Serial Remote Control (SCOM) as provided by Hatteland Technology.
Hatteland Technology’s Serial Remote Control Interface (SCOM) protocol document can be downloaded from:
https://www.hattelandtechnology.com/hubfs/pdfget/inb100018-6.htm
GROUNDING SCREW:
Please review “General mounting instructions” in the “Installation” chapter, pt. 7 for more information.