EMBRON Hatteland X Series, User Manual

Page: 78 / 134

78 User Controls
OSD Menu Functions
IND100064-48
Communication
The unit allows for remote control (adjust brightness for example) and/or accessing internal information
about the unit such as type number, serial number and more. To setup this feature, you first need to
configure the Serial, USB or Ethernet protocol properly to match your external equipment specifications.
The contents of this submenu and choices are listed below.
A more detailed description of the SCOM (Serial/Ethernet Communication) can be found here:
https://www.hattelandtechnology.com/hubfs/pdfget/inb100018-6.htm
Review also the “Pinout Assignments” chapter in this manual for additional help during preparation and/or
installation of external equipment intended to communicate with.
Settings as follows:
“RS232” = Sets the SCOM communication to standard RS-232 protocol.
“2-wire RS-485” = Sets the SCOM communication to RS-485 protocol (Half duplex).
“4-wire RS485/422” = Sets the SCOM communication to RS-485/422 protocol (Full duplex).
“USB” = Sets the SCOM communication to standard USB protocol.
“Address RS” = Set the global unique channel / port ID for the unit (range 0-254).
“Auto IP Address” = Enable or Disable the discovery to assign IP Adress Automatically.
“Fixed IP Address” = You can set the IP address manually (xxx.xxx.xxx.xxx).
● Note: Default mode is “RS232” protocol.