417
rip
RIP route
isis
ISIS route
bgp
BGP route
Default:
None
Command Mode:
OSPF protocol mode
Usage Guide:
When distributing route from other routing protocols into0 the OSPF
routing table, we can use this command
Example:
Example below is the advertisement based on the access-list list 1 of the BGP
route.
Switch#config terminal
Switch(config)#access-list l1 permit 172.10.0.0 0.0.255.255
Switch(config)#router ospf 100
Switch(config-router)#distribute-list 1 out bgp
Switch(config-router)#redistribute bgp
13.6.3.15 host area
Command: [no] host <host-address> area <area-id> [cost <cost>]
Function:
Use this command to set a stub host entire belongs to certain area. The “
[no]
host <host-address> area <area-id> [cost <cost>]
” command cancels this
configuration
Parameter: <host-address>
is host IP address show in dotted decimal notation,
<area-id>
area ID shown in dotted decimal notation or integer ranging between
0~4294967295
<cost>
specifies the entire cost, which is a integer ranging between 0~65535 and
defaulted at 0
Default:
No entire set
Command Mode:
OSPF protocol mode
Usage Guide:
With this command you can advertise certain specific host route out as
stub link. Since the stub host belongs to special router in which setting host is not
important.
Example:
Switch#config terminal
Switch(config)#router ospf 100
Switch(config-router)#host 172.16.10.100 area 1
Switch(config-router)#host 172.16.10.101 area 2 cost 10
13.6.3.16 ip ospf authentication
Command: ip ospf [<ip-address>] authentication
[message-digest|null]
