609
command restores default value.
Parameter: <delay_val>
is the delay of periodically transmitted DVMRP report message,
value range from 1s to 5s.
<burst_size>
is a quantity of transmitted message every time,
value range from 1 to 65535
Default:
Default the delay of transmitted DVMRP report message as 1s, default:
transmitting two messages every time.
Command Mode:
Interface Configuration Mode
Usage Guide:
Avoid message burst if setting an appropriate delay.
Example:
Switch (Config-If-vlan1)#ip dvmrp output-report-delay 1 1024
16.4.3.5 ip dvmrp reject-non-pruners
Command: ip dvmrp reject-non-pruners
no ip dvmrp reject-non-pruners
Function:
Configure to reject neighbor ship with DVMRP router of non pruning/grafting
on the interface, the “
no ip dvmrp reject-non-pruners
” command restores neighbor ship
can be established.
Parameter:
None
Default:
Default
Command Mode:
Interface Configuration Mode
Usage Guide:
The command determines if it will establish neighboring ship with DVMRP
router of non pruning/grafting or not.
Example:
Switch (Config-If-vlan1)#ip dvmrp reject-non-pruners
16.4.3.6 ip dvmrp tunnel
Command: ip dvmrp tunnel
<index> <src-ip> <dst-ip>
no ip dvmrp tunnel
{
<index> |<src-ip> <dst-ip>}
Function:
Configure a DVMRP tunnel; the “
no ip dvmrp tunnel
{
<index> |<src-ip>
<dst-ip>}
” command deletes a DVDMRP tunnel.
Parameter: <src-ip>
is source IP address,
<dst-ip>
is remote neighbor IP address,
<index>
is tunnel index number, value range from 1 to 65525.
Default:
Default: Do not Configure DVMRP tunnel.
Command Mode:
Global Mode
Usage Guide:
Because not all of switches support multicast, DVMRP supports tunnel
multicast communication. The tunnel is a way of transmitted multicast data packet among
DVMRP switches partitioned off switches without supporting multicast routing. It acts as a
virtual network between two DVMRP switches. Multicast data packages packed in
unicast data packages, directly are transmitted to next supporting multicast switch.
