660
neighbors are created, this connections are cut off immediately. If no connection is
created, this connection can’t be created.
Parameter: <acess-list-name>
is the applying access-list’ name
Default:
No neighbor filter configuration
Command Mode:
Interface Configuration Mode
Usage Guide:
ACL’s default is DENY. If configuring access-list 1,access-list 1’s default is
deny. In the following example, if “permit any-source” is not configured, deny 10.1.4.10
0.0.0.255 is the same as deny any-source. The command can configure on IPv6 tunnel
interface, but it is successful configuration to only configure tunnel carefully.
Example:
Configure vlan’s pim neighbor access-list
Switch (Config-if-Vlan1)#ipv6 pim neighbor-filter myfilter
Switch (Config)# ipv6 access-list myfilter deny fe80:20e:cff:fe01:facc
Switch (Config)# ipv6 access-list myfilter permit any
17.2.3.12 ipv6 pim register-rate-limit
Command: ipv6 pim Register-rate-limit <limit>
no ipv6 pim Register-rate-limit
Function:
This command is used to configure the speedrate of DR sending register
packets, the unit is packet/second. the “
no ipv6 pim Register-rate-limit
” command
restores the default value. This configured speedrate is each
（
S, G
）
state’s, not the whole
systems.
Parameter: <limit>
ranges from 1 to 65535
Default:
No limit for sending speed
Command Mode:
Global Mode
Usage Guide:
Configure the speedrate of DR sending register packets
Example:
Configure the speedrate of DR sending register packets to 59 p/s
Switch(config)#ipv6 pim Register-rate-limit 59
17.2.3.13 ipv6 pim register-rp-reachability
Command: ipv6 pim Register-rp-reachability
no ipv6 pim Register-rp-reachability
Function:
This command makes DR check the RP reachability in the process of
registration
Parameter:
None
Default:
Do not check
Command Mode:
Global Mode
Usage Guide:
This command configures DR whether or not to check the RP reachability.
Example:
Configure the router to check the RP reachability before sending register