455
Interface Configuration Mode
IPv6 ospf priority <priority>
[instance-id <id>]
no IPv6 ospf priority [instance-id
<id>]
Sets the priority of the interface in “designated
layer3 switch” election; the “
no IPv6 ospf
priority [instance-id <id>]
” command
restores the default setting.
3. Disable
OSPFv3 Protocol
Commands Explanation
Global mode
no router IPv6 ospf [<tag>]
Disable OSPFv3 Routing Protocol
13.7.3 Commands for OSPFV3
13.7.3.1 area default cost
Command: area <id> default-cost <cost>
no area <id> default-cost
Function:
Configure the cost of sending to the default summary route in stub or NSSA
area; the “
no area <id> default-cost
” command restores the default value.
Parameter: <id>
is the area number which could be shown as digits 0
～
4294967295, or
as an IP address;
<cost>
ranges between <0-16777215>
Default:
Default OSPFv3 cost is 1
Command Mode:
OSPFv3 protocol mode
Usage Guide:
The command is only adaptive to the ABR router connected to the stub
area or NSSA area
Example:
Set the default-cost of area 1 to 10
Switch(config-router)#area 1 default-cost 10
13.7.3.2 area range
Command: area <id> range <ipv6address> [advertise| not-advertise|]
no area <id> range <ipv6address>
Function:
Aggregate OSPF route on the area border. The “
no area <id> range
<address>
“ cancels this function
Parameter: <id>
is the area number which could be digits ranging between 0
～
4294967295, and also as an IP address.
<ipv6address>=<X:X::X:X/M>,
Specifies the area ipv6 network prefix and its length
advertise:
Advertise this area
