Eaton SVCH0203 SPX Advanced, Applications Manual

Page: 156 / 185

147
SPX advanced – description of parameters
SPX ADVANCED APPLICATION MANUAL
SVCH0203—October 2017 www.eaton.com
5.15.2 DIN ID control
This function is used to control any parameter between
two different values with a digital input. Different values are
given for DI ‘low’ and DI ‘high’.
Code ID Description Notes
P1.14.2.1 1570 ID control digital input “ID control DIN”
P1.14.3.1 1590 ID control digital input “ID control DIN”
P1.14.4.1 1578 ID control digital input “ID control DIN”
Select digital input to be used for controlling the parameter selected by ID1571, ID1575
and 1579.
P1.14.2.2 1571 DIN controlled ID ID1571 “controlled ID”
P1.14.3.2 1575 DIN controlled ID “controlled ID”
P1.14.4.2 1579 DIN controlled ID “controlled ID”
Select parameter ID controlled by ID1570.
P1.14.2.3 1572 Value for low digital input (FALSE) “false value”
P1.14.3.3 1592 Value for low digital input (FALSE) “false value”
P1.14.4.3 1594 Value for low digital input (FALSE) “false value”
Set here the controlled parameter value when the digital input (ID1570) is LOW for
the parameter selected by ID1571. The function does not recognize decimals. Give,
therefore, e.g. 10.00 Hz as ‘1000’.
P1.14.2.4 1573 Value for high digital input (TRUE) “true value”
P1.14.3.4 1593 Value for high digital input (TRUE) “true value”
P1.14.4.4 1596 Value for high digital input (TRUE) “true value”
Set here the controlled parameter value when the digital input (ID1570) is HIGH for
the parameter selected by ID1571. The function does not recognize decimals. Give,
therefore, e.g. 10.00 Hz as ‘1000’.
IN
IN
G
DIN Controlled ID
1
0
SEL
P ID Control Digital Input
Value for LOW
Value for High
P
P
DI
5.15.3 ID-controlled DO
This function is used to control any Digital output by
anystatus that can be presented as bit.The input signal is
selected with the ID number and bit number.Example: Most
of the faults and warnings are normallypresented in the
common digital output. With theID-controlled DO function,
it is possible to select a specificfault to be connected to the
digital output.
Warning word 1 ID1174
Fault Comment
b0 Motor stalled W15
b1 Motor over temperature W16
b2 Motor under load W17
b3 Input phase loss W10
b4 Output phase loss W11
b5 Safe disable W30 (Not implemented)
b6 FieldBus communication fault in slot D W53 (Not implemented)
b7 FieldBus communication fault in slot E W67 (Not implemented)
b8 Drive over temperature W14
b9 Analog input < 4mA W50
b10 Not used
b11 Emergency stop W63 (Not implemented)
b12 Run disabled W62 (Not implemented)
b13 Not used
b14 Mechanical brake W58
b15 Not used