Eaton Moeller SmartWire-Darwin EU5C-SWD-CAN, Hardware And Engineering

Page: 35 / 108

easySoft-CoDeSys
31
02/09 AWB2723-1612en
Setting specific parameters of SmartWire Darwin
slaves
You can parameterize the transient behaviour for each
SmartWire-Darwin slave. By doing this you define how the
gateway reacts, if a slave is not available. The standard
setting is that all slaves have to be available. However, the
information as to whether a slave is available is also
reported to the application via the diagnosis so that the
failure of a slave can be reacted to individually here
(
a section "Diagnostics").
Changing the setting
X
Select the corresponding SmartWire Darwin module in the
Inputs/Outputs register in the table “Selected
Modules”.
X
Press the button Properties . The dialogue field Module
Properties relating to the selected module is displayed.
By double-clicking on the entry Device shall be present
(device must be present) in the column Value the setting
for Device may not be present (device does not have to
be present) changes.