EarthLinked SCWD-024-1C, Quick Start Instructions

Page: 7 / 62

SCWD-QS (12/16) Page 7
Installation
1) Component Matching
Upon receipt of the equipment, carefully check the component model numbers by referencing
Figure 1, to ensure that all components of the system match.
Classic Systems
Compressor Unit
1
Hybrid Cooling Module Earth Loop
2
-024
HCM-1860C
-024-C
-030 -030-C
-036 -036-C
-042 -042-C
-048 -048-C
-060 -060-C
1. Contained in each compressor package: compressor unit; four L-shaped hold
down brackets; service valves-liquid and vapor; adapters for service valves and
earth loop line set; product literature
2. All series Earth Loops
Figure 1. Matching Component Model Numbers
Guidelines for the general layout of the system components are shown in Figure 2. Before placing the
compressor unit (outside or indoors), review the guidelines in Figure 2.
INSTALLATION GUIDELINES

All refrigerant and water lines between these above ground components must be insulated
with at least 1/2” wall thickness Armaflex, Insul-Tube or equivalent insulation. Thicker
insulation is recommended for the Compressor Unit-to-Air Handler refrigeration lines for sound
isolation

If you plan to exceed the 40 ft. max elevation of the Air Handler, please contact our Tech
Support Department. Increased height will reduce performance and shall be factored into
system sizing.

The Hydronic Water Module (HWM) shall always be mounted above the Compressor Unit,
never below
Warning!
WEAR ADEQUATE PROTECTIVE CLOTHING AND PRACTICE ALL
APPLICABLE SAFETEY PRECAUTIONS WHILE INSTALLING THIS
EQUIPMENT. FAILURE TO DO SO MAY RESULT IN EQUIPMENT
AND/OR PROPERTY DAMAGE, PERSONAL INJURY OR DEATH.