Dürkopp Adler 878-160722-M, Operating Instructions Manual

Page: 99 / 180

Operating Instructions 878-M PREMIUM - 06.0 - 11/2021 97
6.5.3.2 Setting the
Correction speed effect
parameters
Some parameters are affected by high speeds because of
the resulting physical effects. To counteract these effects and
to achieve consistent results, even at high speeds, adjustment
factors can be set depending on the speed.
Overview of settings modes
The correction of the effects of high speeds can be identified in
various modes and responded to depending on the setting.
This general explanation can be applied to the following specific
parameters.
Setting mode Description
linear
In the linear setting, the size of the parameter increases
or decreases steadily as the speed increases.
The increase/decrease of the parameter depends on
the limits set for the minimum and maximum speed.
2. Value
On/Off
If a certain speed is exceeded, the 2
nd
value of the
parameter is activated. If the speed then falls below
this level again, it switches to the base value for the
parameter.
2. Value
On
If a certain speed is exceeded, the 2
nd
value of the
parameter is activated. If the speed then falls below
this level again, it does NOT switch to the base value
for the parameter.
Only after finishing the seam by cutting the thread is
the base value for the parameter set again.