Dürkopp Adler 878-160722-M, Operating Instructions Manual

Page: 94 / 180

92 Operating Instructions 878-M PREMIUM - 06.0 - 11/2021
6.5.3 Setting cross-segment
parameters
There are various options for setting the cross-segment parame-
ters. The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Icon Parameter Settings
Additional values (+)
Additional value stitch length (+)
The 2
nd
value for the stitch length can be
switched on using a button on the push
button panel or the tile on the control
panel.
Value range
0.1 to 7.0 [mm]
(depending on sewing equipment
and subclass)
Additional value needle thread tension (+)
The 2
nd
value for the needle thread ten-
sion can be switched on using a button
on the push button panel or the tile on the
control panel.
Value range
01 to 99 [%]
Additional value of upper fullness (+)
The 2
nd
value for the upper fullness can
be switched on using a button on the
push button panel, with the knee button
or with the button on the control panel.
Value range
-6 to 16
Additional value of lower fullness (+)
The 2
nd
value for the lower fullness can
be switched on using a button on the
push button panel, with the knee button
or with the button on the control panel.
Value range
-6 to 16
Gap (2
nd
value)
The 2
nd
value for the gap between the
motor-driven edge guide and the needle
(factoring in the defined safety distance to
the sewing feet).
Value range
8.0 to 45.0 [mm]
Main Parameter
Bobbin monitor mode
(see 
p. 95
)