58
Function Setting
CPM on pos adj
(When the
CPM (cross tool module (option))
is installed only)
This adjusts processing start position of the
CPM (cross tool module)
.
RTM on pos adj
(When the
RTM (rotary tool module (option))
is installed only)
This adjusts processing start position of the
RTM (rotary tool module)
.
Read Barcode (Barcode reading)
This reads a barcode printed on a document and automatically programs it for a JOB.
Default is
ALL
.
Reject
Double-fed documents or documents with reading an error (REG mark or Barcode) are ejected to
the
reject tray
automatically.
Waste detection
This sets the detection timing of
waste box full
. When
waste box full
is detected,
waste box
full
message appears on the LCD panel.
Defaut is
ON
.
< Function Setting 2 >
DBL detection (double feed detection)
This detects a double feed (two or more sheets are fed at once).
Default is
ON
.
CPM o
ff
pos adj
(When the
CPM (cross tool module (option))
is installed only)
This adjusts processing end position of the
CPM (cross tool module)
.
RTM o
ff
pos adj
(When the
RTM (rotary tool module (option))
is installed only)
This adjusts processing end position of the
RTM (rotary tool module)
.
Feeder capacity
The elevator level can be adjusted to three levels according to the document quantity.
Default is
MAX
.
Basic mode
You can select
Simple mode
or
Advanced mode
for entering a JOB.
Barcode digit
When reading a 2-digit barcode, use
2Digits
. When reading a 3-digit barcode, use
3Digits
.
REFERENCE
For detailed information, contact your dealer.
REFERENCE
Settings for each function are active after the power is turned
OFF
as well.
