Programming a JOB in Advanced Mode
39
Programming a JOB on the Control Panel
2
Cut trim mode
Use the CURSOR (Right/Left) key to select
Full bleed mode
,
No bleed mode
or
Process all
, and press the SET key or the
CURSOR (Down) key.
Full bleed mode
: Chops up the lead margin, the trail margin, and
the gutters of 48.9 mm or shorter.
No bleed mode
: Chops up the gutters of 48.9 mm or shorter.
Process all
: Ejects all of the cut pieces to the
exit tray
except
that the lead margin and the gutters of 27.9 mm or
shorter and the trail margin of 48.9 mm or shorter
are chopped up.
REFERENCE
If there is no lead margin or trail margin on the document, select
No bleed mode
.
Cut
(0/***.*-***.*)
***.*mm
Cut1
Cut
Enter the distance from the lead edge of the document to the
position for
Cut1
using the NUMERIC keys and press the SET
key or the CURSOR (Down) key. This value must be smaller than
that set for the document length.
If you enter
0
or the value of the cut position is in the area of 5
mm from the trail edge, the
Crease
screen appears.
Cut trim mode
Cut
Full bleed mode
Slit/RTM is at
55.1-60mm and
95.1-100mm.
Change Slit/RTM
positions.
Non-operator’s side
Operator’s side
Slit
Gutter slit
100 mm
Slit
Gutter slit
95.1 mm
60 mm
55.1 mm
1
2
Document
feed
direction
• Gutter slits, slits, and the
RTM (rotary tool module (option))
are allocated to the locations that prevent the sensor from
sensing a document.
The message appears when the following conditions of
1
and
2
are met simultaneously.
1
: (55.1 to 60 mm)
2
: (95.1 to 100 mm)
Re-enter slit locations so that either of these conditions is
outside the speci
fi
ed range.
REFERENCE
