64
Function Setting
Feeder capacity
The elevator level can be adjusted to the three levels below
according to the document quantity.
MAX
: When loading high quantity of documents
MIN
: When loading low quantity of documents
Use the CURSOR (Right/Left) key to select
MAX
,
MID
, or
MIN
and press the CURSOR (Down) key.
Waste detection
This sets the detection timing of
waste box full
. When
waste
box full
is detected, an error message appears on the LCD
panel.
Use the CURSOR (Right/Left) key to select
MAX
,
MID
, or
OFF
and press the CURSOR (Down) key.
MAX
: Detects
full
when the waste comes to 70% of the waste
box.
MID
: Detects
full
when the waste comes to half of the waste box.
• The dotted line in the
fi
gure on the LCD panel is a rough guide of
waste box full
.
• This function is only for when processing light weight documents or short documents.
REFERENCE
Waste detection
Settings2
MID
*/**
Basic mode
You can select
Simple mode
or
Advanced mode
for entering a
JOB. Use the CURSOR (Right/Left) key to select
Simple mode
or
Advanced mode
and press the CURSOR (Down) key.
Basic mode
Simple mode
Settings2
*/**
Simple mode
: The appropriate modules are automatically
designed after you entered all the processing
values.
Advanced mode
: You can set all the modules and tools
alternately from side to side in order of module
along the document feeding direction.
CPM on pos adj
You can adjust a processing start position when
the
CPM
(
cross
tool module (option))
is installled.
Use the CURSOR (Right/Left) key to select shift direction (+/-
), and use the NUMERIC key to enter a value. Then press the
CURSOR (Down) key.
+: Shifts a processing start position toward the operator's
side.
−
: Shifts a processing start position toward the non-operator's
side.
Settings2
+0.0mm
CPM on pos adj
*/**
Feeder capacity
MAX MID MIN
Settings2
*/**
CPM o
ff
pos adj
You can adjust a processing end position when the
CPM (cross
tool module (option))
is installed.
Use the CURSOR (Right/Left) key to select a shift direction (+/-
) and use the NUMERIC key to enter a value. Then press the
CURSOR (Down) key.
+: Shifts a processing end position toward the operator's side.
−
: Shifts a processing end position toward the non-operator's
side.
Settings2
+0.0mm
CPM o
ff
pos adj
*/**
