See Figure 6-21. For each limit that is important to
your application, use the drop down menu, and select
Display
.
These parameters will be displayed on the
Cycle Data
screen, and may be important for subsequent analysis
of the weld process.
Once the process settings are fully developed for the
application, the Process Limits can be set to Suspect
and/or Bad to identify part assemblies of inferior weld
quality.
Step 15 - Specify Process Limits Behavior
Figure 6-21
iQ Explorer II
, Process Limits Tab
Process Limits Tab
Show No Limits - Sets all
of the process limits to
not display any limits.
Show All - Sets all of
the process limits to
be Displayed.
Page 109
Dukane Manual Part No. 403-587-00
Section 6 - Optional Control
