Dräger Savina 300, Technical Documentation Manual, Page: 149 / 166

6DYLQD 5HYLVLRQ
No
.0
208
_0
00
000
25
33
_Pu
bl
ic
ati
o
n
39 / 50
Function and condition test
Function tests
Action • Press the „Alarms“ softkey and set the following parameters:
– MV high: 41 L/min
– MV low: 0.5 L/min
– Paw: 100 mbar
– VTi: 4.00 L
– f: 120/min
– Tapn: 60 s
Action • Press the „Sensors/Parameters“ softkey and set the following parameters:
– O2 monitoring: On
– Flow monitoring: On
Action • Press the „System configuration“ softkey.
• Press the „Ventilation“ softkey and set the following parameters:
– Pressure limitation: Off
– Plateau: On
– LPO: Off
• Start ventilation with the Savina 300.
O2 calibration
Action • Select the „Sensoren/Parameter” menu.
• Press the O2 calibration „Start“ softkey and confirm with the rotary knob.
Test The message „Disconnect patient“ is displayed.
Action • Disconnect the ventilation tube from the inspiratory socket.
Test The display shows „O2 calibration in progress“ and then „Reconnect patient“.
Action • Reconnect the ventilation tube to the inspiratory socket.
Test The following message is displayed: „O2 calibration OK“
Entry [________OK]
VT flow control and VT measurement
Action • While the test lung is being ventilated, push the Spirolog sensor to the left-
hand end position and back to the right-hand end position in order to trig-
ger a flow calibration.
• After the display message „Flow calibration OK“ appears, ventilate the test
lung for at least another three cycles.
• Read out the „VTe“ measured value and compare it with the specified toler-
ance range.
VT=500 mL (expiratory valve 1)
The displayed value is in the range from 440 mL to 540 mL.
Entry [________mL]
Action • After the tidal volume measurement (VT) perform a flow calibration.
NOTE
Perform the „VT metering and VT measurement“ test with all the expiratory
valves listed in the „Device configuration“ section under „Serial numbers“.