DPS NetGuardian 832A, User Manual

Page: 46 / 107

41
5. Attached the left side of the hinged
panel to the rack with the screws
provided.
6. Unlock the back panel by turning the black swivel to
the horizontal position. (See Figure 6.12.1) Plug the
amphenol cables in to the hinged back panel and
secure them with the Velcro straps. Make sure the
NetGuardian's silk screen matches the hinged panel
where the amphenols are connected.
7. Tighten the 2 screws located to the
right of the amphenol cables. Use the
plastic zip ties provided to secure both
cables to the NetGuardian where
shown (bottom image).
Note: A zip tie
will be used on the NetGuardian's
small metal tab to secure the left
amphenol cable. If your remote is
equipped with the 4-pin analog
connector, connect it to the
NetGuardian
and to the DB9 on the
hinged panel.
8. Use the remaining zip ties to keep the amphenol cords
tied together. Trim the excess plastic off the zip ties
with scissors.
9. Close the back panel and lock it by turning the black swivel to the vertical position.
NOTE: The