DPS NetGuardian 832A, User Manual

Page: 38 / 107

33
6.8.7 D-Wire Sensor Inputs
The port on your NetGuardian labeled D-Wire supports up to 16 D-Wire s ens ors . Your NetGuardian
powers and communicates with your D-Wire sensors via simple RJ-11 connection.
Note: The DPS Temperature and Humidity Sensor, DPS part number D-PK-DSNSR-12002, occupies
two nodes.
6.8.7.1 Connecting D-Wire Sensors
Using a standard 6P4C, straight-through RJ-11 cable (part number D-PR-045-10A-01, pinout below),
connect the D-Wire port on the NetGuardian to the In jack on the D-Wire Sensor. Chain additional
sensors to the D-Wire sensor (using the same straight-through cables) from the Out jack on the
previous sensor to the In jack on the next (i.e. Out on sensor 4 to In on sensor 5).
Fig. 6.8.6.1.1 Pinout for the NetGuardian and D-Wire Sensor RJ-11 jacks
For details about configuring your sensors through the web interface see the Sensors section of this
web browser user manual.
Optional 66 Block Connector (832A) 6.9
Both of the 50-pin connectors on the back panel of the NetGuardian can be connected to the optional
25-pair 66 Block Connector (part number D-PR-966-10A-00). For 66 block pinout and color code
information, see Figure 6.9.1 for Discretes 1–24 and Figure 6.9.2. for Analogs 1–6/Discretes 25–32/
Relays 1–8.
Note: The 66 Block supports termination of 22 - 26 AWG (0.81 - 0.41mm) solid insulated cable or 18 -
19 AWG (1.02 - 0.91mm) solid stripped cable. DPS recommends using 24 AWG wire (solid).
Note: If connecting to a 50-pair split block, all connections should be made on the two pin columns
closest to the right-hand side of the block or bridge clips should be installed.