Operating Manual
© Dürr Systems AG
EcoBell2 SL EC - Rotating Atomizer with External Charging
Cleaning and maintenance
Document No.: MRA00001EN
Version:: 07
•
As of:: 01/2020
97 / 156
Fig. 48: Dismantling the distributor disk
1
Assembly tool
2
Distributor disk
• Place the front side of the bell disk on the cloth.
• Put the tool in the opening on the rear of the bell disk.
• Press the tool into the bell disk with the ball of the thumb using
normal manual force.
• With a light push, the distributor disk gets released from its seat in
the bell disk.
If the distributor disk is released from the bell housing without a push,
the retaining ring of the distributor disk must be checked.
• Remove the special tool from the housing of the bell disk.
Checks at the distributor disk and bell disk
Distributor disks can only be cleaned. Damaged distributor disks
cannot be repaired. They can only be replaced by new distributor
disks.
After dismantling the distributor disk, check the following:
- Cleanliness and condition of the distributor disk and the position in
the bell disk housing.
Both must be clean and without residue. Soiling in these areas can
cause an uneven distribution of paint.
- Damage to the distributor disk that originates from contact with the
nozzle.
Replace damaged distributor disk.
