Docomo SH-05A, Instruction Manual

Page: 55 / 556

e03_dr20_7e.fm
[53/74]
53
Continued on next page
Vo
ic
e/Vi
d
eop
ho
ne
C
all
s
Calls may be interrupted even when the signal is strong ([
]
] appears)
and you are not moving.
To call selecting a Multi Number n P. 398
To call selecting a phone number when the 2in1 is used
n
P. 399
1
In stand-by, enter a phone number.
:
Always enter the area code even when the
number is in the same area.
:
Enter up to 80 digits.
:
To erase the last digit: Press
c
.
:
To erase all digits: Press
c
(for 1+ seconds).
2
Press
s
(Phone)/
i
(V.phone).
:
Unlike ordinary telephones, mobile phones send call tones in short
beeps before the standard ring tone.
:
When the other party is busy, there is a busy signal. Disconnect and
try again later.
Key operations during a voice call
:
To enable/disable hands-free: Press
s
(for 1+ seconds).
Key operations during a Videophone call
:
To enable/disable hands-free: Press
s
.
:
To switch between a substitute image and My side: Press
i
.
3
Press
H
to end the call.
Making a voice/Videophone call
When the 2in1 mode is set to [Dual mode], the screen for selecting a
phone number appears after step 2. Select the phone number.
Voice calls
Calls can be made even when steps 1 and 2 are reversed. If no
operations are performed for approximately 5 seconds after entering
the phone number, the call is made.
Videophone calls
A Videophone call is not connected when placed to an unsupported
handset. In addition, it is not connected to devices for which 64K cannot
be used due to network conditions.
If Call Waiting is subscribed to, the number is recorded in Received
calls and the stock icon [
B
] (missed call) appears when a voice/
Videophone call is received during a Videophone call.
When the sending/receiving of audio or video fails, the Videophone call
is not automatically restored. Make the Videophone call again.
When the Videophone call does not connect
When the Videophone call does not connect, a message explaining the
reason appears. The other party’s actual conditions may vary
depending on the type of phone and network service subscriptions.
[Check number, then redial]: A call is made to unused phone
number.
[Busy]: The other party is engaged in a call (This message may
appear during a packet transmission depending on the other party’s
terminal).
[Your call is being forwarded]: The other party’s handset is set to
forward Videophone calls.
[Out of service area/power off]: The other party is outside the service
area, or their mobile phone is turned off.
[Set caller ID to on]: Connected without notifying the caller ID (when
calling the visualnet, etc.).
[Redial using voice call]: The other party’s handset is set to the Call
Forwarding Service and the forwarding destination does not support
Videophone.
[Busy with packet transmission]: The other party is performing a
packet transmission.
[Upper limit has been exceeded. Connection failed]: Upper limit set
by payment plans with limit function (Type Limit or Family Wide
Limit) has been exceeded.
[Please make your call from the i-mode web page]: A Videophone
call is directly made to the V-live which should be accessed after
connecting to i-mode. Access a site run by the contents provider and
view it by making a Videophone call from the link.
dr20_E.book 53 ページ ２００９年５月１４日 木曜日 午前１０時１７分