Docomo SH-05A, Instruction Manual

Page: 50 / 556

48
e02_dr20_7e.fm
[48/50]
Be
fore
Us
ing
the
H
andset
During a voice/Videophone call, the alert tone sounds and [Battery
empty. Unsaved data will be lost. Ending current operation] appears. The
call is disconnected after approximately 20 seconds. At the same time,
the screen above appears and after approximately 60 seconds, the
power turns off.
Alert tone does not sound when Manner mode or Public mode (Drive
mode) is set (Alert tone sounds during a call).
1
Press
H
(for 2+ seconds).
: It may take some time for the wakeup screen to appear.
: The wakeup screen appears followed by the initial settings screen.
Proceed to Initial setting (
n
P. 48).
: If initial settings have been completed, the
screen shown on the right appears when
power is turned on. This screen is called the
“stand-by display”.
Welcome mail
:
“Welcome
-
ドコモ動画
#
”
(Welcome
-
docomo-doga
#
) and “
緊急速報
「エリアメール」 のご案内
” (Information of Early
Warning “Area Mail”) are saved by default.
:
To check a welcome mail: In stand-by, press
t /
select the stock icon [
C
] (mail
message)
/ t
.
• For details on the following operations
n
P. 136
1
Press
H
(for 2+ seconds).
:
It may take some time for the power to be turned off (The end screen
appears on the display until the power is turned off).
1
In the Custom menu, select [Settings]
/
[ 一般設定 ]
/
[Bilingual]
/
[English].
:
To switch the display language from English to Japanese: In the
Custom menu, select [Settings]
/
[General settings]
/
[Select
language]
/
[
日本語
].
The initial settings screen appears automatically when the power
is turned on for the first time. Each setting item can also be set
from Menu (When the initial settings are complete, the stand-by
display appears).
Power ON/OFF
Turning power ON/OFF
Turning power ON
If initial settings are not yet completed, the setting screen appears every
time the power is turned on.
If the FOMA card is not inserted, [Insert UIM] and a FOMA card error
appear (
n
P. 34).
When [Enter PIN1 code] appears, enter the PIN1 code (
n
P. 107).
Stand-by display
When a FOMA card is replaced with a new card, the terminal security
code (four to eight digits) must be entered after turning on the terminal.
If a correct terminal security code is entered, stand-by display appears.
When a wrong terminal security code is entered five times, the power is
turned off. However, turning on the power again is possible.
When [
A
] appears, the handset is outside the service area or in a
place with no signal. Move to a place where the icon disappears.
Turning power OFF
Select language
Changing screen display to English
If a FOMA card is inserted, settings are saved to the FOMA card as
well. When the setting of the FOMA terminal handset and the setting of
the inserted FOMA card are different, the setting in the FOMA card is
prioritized.
Initial setting
Making initial setting
dr20_E.book 48 ページ ２００９年５月１４日 木曜日 午前１０時１７分