DINGLI BA14J-AWD, Operation And Maintenance Manual

Page: 10 / 97

Operation & Maintenance Manual Section1-Safety Precaution
Dingli Machinery
1-4
controls with slow and even pressure. Hydraulic cylinders should never be left fully
extended or fully retracted before shutdown or for long periods of time.

Do not allow personnel to tamper with or operate the machine from the ground with
personnel in the platform, except in an emergency.

Do not carry materials directly on platform railing.

When two or more persons are in the platform, the operator shall be responsible for all
machine operations.

Always ensure that power tools are properly stowed and never left hanging by their cord
from the platform work area.

Supplies or tools which extend outside the platform are prohibited unless approved.

When driving, always position boom over rear axle in line with the direction of travel.
Remember, if boom is over the front axle, steer and drive functions will be reversed.

Do not assist a stuck or disabled machine by pushing, pulling, or by using boom functions.
Only pull the unit from the tie-down lugs on the chassis.

Do not place boom or platform against any structure to steady the platform or to support
the structure.

Stow boom and shut off all power before leaving machine.
Trip and Fall Hazards
During operation, occupants in the platform must
wear a full body harness with a lanyard attached
to an authorized lanyard anchorage point. Attach
only one (1) lanyard per lanyard anchorage point.

Before operating the machine, make sure all gates are closed and fastened in their proper
position.