Digital Projection E-Vision Laser 15000 Series, Installation & Quick Start Manual

Page: 6 / 145

Digital Projection E-Vision Laser 15000 Series Contents
Introduction 2
About this document 3
Symbols used in this document 3
Product revision 3
Additional Documentation 3
Legal notice 3
Third Party Credits 3
Electrical and Physical Specifications 4
Laser Parameters 4
Compliance with International Standards 5
RF Interference 5
Noise 5
European Waste Electrical and Electronic Equipment (WEEE) Directive 5
Contents 6
General Precautions 10
What's in the box? 12
Projector overview 13
Location of Laser Aperture 14
Interlock Switches 15
Installation Precautions 16
Laser Safety Precautions 19
Risk Group 3 Laser Hazard Installation Precautions 20
Light Hazard Warning 20
Light Hazard Distance and Hazard Zone 20
Fitting a lens 21
Inserting a new lens 21
Removing the lens 22
Fitting a lens hood 23
Positioning the screen and projector 24
Power Supply 25
AC Power Precautions 25
Connecting the power supply 26
Voltage selection 26
Operating the projector 27
Control panel 27
Projector indicators 28
Remote control 29
Infrared reception 33
Switching the projector on 33
Switching the projector off 33
Interlock reset 33
Selecting an input signal 34
Selecting a test pattern 34
Adjusting the lens 35
Adjusting the image 35
Orientation 35
Geometry 35
Picture 35
Signal inputs 38
Digital inputs and outputs 38
EDID on the DisplayPort, HDMI, and HDBaseT inputs 39
Using DisplayPort / HDMI / HDBaseT switchers with the projector 39
Analog inputs and outputs 40
3D connections 41
3D frame packed, side-by-side and top and bottom formats 42
Frame sequential 42
Dual Pipe (Left/Right) 42
3D Sync 43
Control connections 44
LAN connection examples 45
RS232 connection example 46
Using the menus 48
Opening the Menu 48
Opening a submenu 48
Exiting menus and closing the OSD 49
Inside a menu 49
Accessing sub menus 50
Executing commands 50
Rev B April 2021
page 6
Introduction
Notes
Contents