Fitting a lens
Digital Projection E-Vision Laser 15000 Series
Fitting a lens
The projector must be fully
turned off prior to attempting a
lens change.
When changing the lens, avoid
using excessive force as this
may damage the equipment.
Avoid touching the surface of
the lens as this may result in
image impairment.
FDA regulations require that a lens
hood (p/n:121-867) is permanently
fitted when using the 3.58 - 5.38 : 1
zoom lens or the 5.31 - 8.26 : 1
zoom lens with the E-Vision Laser
15000 projector in the United
States of America. Fitting can be
provided by your reseller or System
Integrator.
The lens is shipped separately.
Take care to preserve the original
lens packaging and protective caps
for future use.
The projector will not turn on the
light source without a lens fitted
Inserting a new lens
1. Remove the lens aperture cap or lens from the projector. See Removing the lens on the
next page for guidance on removing a lens.
2. Remove the front and rear lens caps from the lens.
3. Position the lens so that the labels are at the top, and gently insert it all the way into the
lens mount.
4. Push the lens in firmly and turn it clockwise until it clicks into place.
Installation & QuickStart Guide
Rev B April 2021
page 21
Notes
