Digital Projection E-Vision Laser 15000 Series
General Precautions
General Precautions
Warning! Death or Serious Injury could occur if the following precautions are ignored
Eye Hazard! Do not look directly into the lens when the light source is on. The high brightness can cause permanent eye damage
Fire Hazard! Keep any combustible material away from hot surfaces and the projected beam. Ensure cables do not contact hot surfaces
Shock Hazard! Use only authorised components, tools, accessories and replacement parts specified by the manufacturer
Trip Hazard! Locate cables where they cannot be pulled, tripped over or damaged by persons or objects
Operate the product in the specified operating environment and conditions
Product should be powered off and disconnected from the mains before any service or maintenance operation
Keep body parts, hair, clothing and jewellery away from moving parts in the product.
Do not operate the product without a lens installed
Use a lens plug when installing or moving the product
The unit is never to be operated if the unit is defective or the cover or seal is damaged.
No maintenance allowed by end user.
Do not open the cabinet. There are no user serviceable parts inside.
No service is allowed except by authorized personnel.
Use only the power cable provided.
Ensure that the power outlet includes a Ground connection, as this equipment MUST be earthed.
Take care to prevent small objects such as paper or wire from falling into the projector. If this does happen, switch off immediately, and have the
objects removed by authorised service personnel.
Do not expose the projector to rain or moisture, and do not place any liquids on top of the projector.
Unplug before cleaning, and use a damp, not wet, cloth.
Do not touch the power plug with wet hands.
Do not touch the power plug during a thunder storm.
Handle the power cable carefully and avoid sharp bends. Do not use a damaged power cable.
Rev B April 2021
page 10
Introduction
Notes
