3D connections
Digital Projection E-Vision Laser 15000 Series
3D connections
Set
3D Format
in the 3D menu to
match the format of the incoming
signal. See 3D on page 83.
See 3D formats on page 127 for
information about supported 3D
signal input modes.
1
2
5
WIRED
REMOTE
HDBaseT/LAN
HDMI 1
DISPLAYPORT
DVI-D
IN
OUT
HDMI II
IN
TRIGGER
RS-232
V
H
B/Pb
G/Y
R/Pr
VGA
OUT
MONITOR OUT
SDI
3D SYNC
USB
3
6
4
1.
HDBaseT
Receives 3D signal from HDBaseT-compliant
devices. Connect an HDBaseT cable.
2.
HDMI I / Dual Pipe Left
HDMI 1.4b input supporting
Frame Sequential
and
Dual Pipe
3D with HDCP 1.4. Also supports the
domestic Blu-Ray formats. Connect an
HDMI
cable to
the connector.
3.
DVI-D
Single Link DVI-D input supporting 3D Frame
Sequential up to 30Hz per eye. Also supports the
domestic Blu-Ray formats.
4.
DisplayPort
DisplayPort 1.1a input supporting
Frame Sequential
3D source up to 120Hz. Connect a
DisplayPort
cable to the connector.
5.
HDMI II / Dual Pipe Right
HDMI 1.4b input supporting
Frame Sequential
and
Dual Pipe
3D with HDCP 1.4. Also supports the domestic Blu-Ray formats. Connect an
HDMI
cable to
the connector.
6.
Sync In / Sync Out
Sync In is the 3D sync input signal. Connect the 3D sync from your graphics card or server.
Sync Out is the 3D sync output signal. This is affected by settings in the 3D menu such as Dark Time and 3D Sync Offset. Connect this to an IR emitter or
ZScreen.
Connection Guide
Rev B April 2021
page 41
Notes
