Using the projector
Digital Projection E-Vision Laser 15000 Series
Position and Phase
Some of the settings within the
Position and Phase sub-menu,
Phase, Tracking and Sync Level,
affect only VGA input source.
These settings are not available if
the projector is using a different
source.
Adjust the Phase after adjusting
Tracking.
Position and Phase
V Position
100
H Position
100
Phase
100
Tracking
100
Sync Level
100
l
V Position, H Position
Set the sliders as required.
l
Phase
Adjusts the phase of the pixel sampling clock relative to the incoming signal. Adjust the phase if noise
is visible.
l
Tracking
Adjusts the frequency of the pixel sampling clock. Flicker or vertical banding indicate poor tracking.
l
Sync Level
Adjusts the voltage level of the signal detection circuitry. Adjust if the projector loses sync during
scenes where the signal drops below black.
Highlight the setting you wish to edit, and then press ENTER/OK, or the LEFT or RIGHT arrow button to
open the slider.
Use the LEFT and RIGHT arrow buttons to adjust the slider.
Press EXIT to close the slider and return to the menu, or MENU to exit both the slider and the menu.
Operating Guide
Rev B April 2021
page 57
Notes
